Audi s3 65 plate saloon revo remapped - Jerky gear change when moving off.

[samis3]

Hi nees advicw on this issue.
My s3 8v saloon 65 plate has recently started jerking when moving off and makes a "click" noise everytime you put it into drive.
I have owned the car for 2 years now and drive it daily. It has always been serviced on time and its dsg service just done yesterday
but that hasnt fixed the jerking when moving off?

Any advice on what this issue is? Also car is revo stage 1 mapped.

 

[dave_beastttt]

Try this, get in the car, press the accelerator fully to the floor until you feel it click, then turn the ignition on, leave the accelerator depressed for at least 30 seconds. Then turn off the ignition, release your foot from the accelerator. Then start the engine and drive off as normal, this should "reset" the gearbox.

 

[samis3]

Try this, get in the car, press the accelerator fully to the floor until you feel it click, then turn the ignition on, leave the accelerator depressed for at least 30 seconds. Then turn off the ignition, release your foot from the accelerator. Then start the engine and drive off as normal, this should "reset" the gearbox.

I tried this no luck. Took to a specialist who diagnosed as knackerd clutch as to much lanuches and needs a mechatronic rebuild. Getting it done soon its a 2.5k job