Car cutting out with camshaft sensor error

[A noddy]

Hi there looking for help ! 2010 Audi s3 rough idle and cutting out.
Did a vcds scan and got a few codes as attached .
I have changed the camshaft sensor but no change.
I recently changed the cam shaft follower and the pcv valve timing belt was done at 90k car currently at 120k . Could it be the crankshaft chain ? Any advice is greatly appreciated cheers John

 

[NHN]

That's allot of errors tbh, have you checked the wiring to all these.

 

[A noddy]

That's allot of errors tbh, have you checked the wiring to all these.

I had my vcds on, trying to check it running and it gave me a -2 then when I revved it went to -3 so I assume from that it's working . The door faults are broken wires in the door loom I haven't got round to fixing and abs one is a concern cheers

 

[A noddy]

Car is fixed ...turns out that it was the Crank shaft position sensor, which in turn affected the camshaft position which flagged the code cheers all !
Car would run fine get up to temp then have a massive loss of power then fail to start ...then eventually go if it happens to anyone else. Cheers