Hello. I’m swapping wheels for a lighter set and I’m not sure whether I should go with black or silver.
The car is Daytona with black optics, so black wheels would look menacing for sure but I find they lose a lot of detail and contrast.
Silver would greatly show the wheel design, I have seen...
I have seen several cases of side skirts and fenders damaged by rock debris when spacers are used.
How’s the 8Y in this regard, are you doing anything to protect when running the typical 12.5/15mm setup?
Thanks
No, I tried a few approaches but it’s always going back to Auto, and unfortunately downshifting way too early for my tastes.
If I’m missing anything, I’m all ears!
I had an 8V S3 which was perfect, and only downshifted if decelerating to 1000 rpm or so.
On the RS3 it scales back almost...
Yes guys you are right, but I asked them last week and still haven’t received a reply.
That’s why I was asking here, though this exhaust is not very common.
I would like to know if the ASR module will work with an Akrapovic exhaust.
I have the module and it’s working great with stock exhaust, now can I simply swap the exhaust with the Akra and keep the ASR as it is without further work?
I’d rather not mess with the Akra remote controller if not...
Even in ECO or comfort mode, I still find the gearbox to downshift too early when decelerating, is there any way to keep it in M so that it stays in the selected gear?
Thank you
Mmm ok, I was specifically looking for the rear.
H&R code 2055573A seems to be ok for the rear, as recommendation is:
- Only suitable for cars with a max. wheel hub length of 15 mm
- Only suitable for wheels with an inner bavel of minimum 6x45°
Thank you.
On the compatibility chart I can’t see RS3 8Y, only 8V… can you confirm these are the correct ones?
https://www.dpmperformance.co.uk/car-parts/audi/rs3/hr-trak-10mm-hubcentric-wheel-spacers-boltsrs3-8v-20152019
Thank you, I see your point.
I’m specifically looking for 10mm because I only want to give a slight touch to the rear axle.
The front looks ok to me as it is, and I’m not planning on lowering the car.
I’m struggling to find good quality 10mm spacers for the new RS3.
12.5 and 15 are quite common, but where can I find 10’s?
Thank you for your suggestions
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.