Please check my VCDS log. Timing advance?

[paultownsend]

I was doing some logging tonight on my k03 AGU. This has been mapped on standard fuel, but i now always use Vpower.. I only have basic VCDS so normally only log inlet temp and maf mg/s.

good news is that it was 16'c outside and inlet temps averaged 6' above with my new THS FMIC, at one point matching ambient. Bad news is the BTDC timing advance. Am i reading this wrong, or using an incorrect setting? As that is MEGA advance!



Inlet

T.B. Angle	Ign. Timing	Mass Flow	RPM	Voltage	Temperature
°	°BTDC	g/s	/min	V	°C

43.8	13.5	49.09	2720	13.51	18
33.4	23.3	47.78	3160	13.51	18
23	37.5	34.65	3360	13.58	16.5
22.1	39	33.33	3520	13.58	16.5
23.4	39	50.83	3880	13.51	16.5
85.1	22.5	130.83	4720	13.44	18
85.1	27	144.44	5560	13.44	19.5
85.1	27.8	147.22	6200	13.37	21
14.3	33	14.51	4440	13.58	18
85.1	25.5	131.25	4560	13.44	21
85.1	24.8	137.84	4920	13.51	21
85.1	26.3	141.81	5200	13.44	22.5
85.1	27	143.96	5480	13.3	24
85.1	28.5	144.31	5720	13.44	24
13	30.8	30.9	4520	13.65	22.5
26.5	37.5	40.76	4360	13.65	21
24.7	39.8	44.37	4360	13.58	21
64.2	25.5	116.25	4480	13.44	24