Hello guys,
I just finish installing my turn signal switch and cruise control on my 2005 Audi A3 S line Sportback 3.2 V6. My turn signal switch is a type 1 Ref. 8P0 953 513 B my previous switch was a type 1 as well, my cars steering wheel control module is a 1K0 953 549 AF which is a Midline variant, I've done the coding. I started with the engine so [01 – Engine] [Login – 11] Enter 11463 to activate cruise control. The engine coding was accepted. Then i coded the Steering Wheel module so [16 – Steering Wheel] [7 - Coding] [00xxx?x] I change the number before the last digit from a 1 to a 4. The Steering Wheel module accepted the coding.
I did all the coding with the ignition on engine not running, I check if the coding on the Steering Wheel module had register it had change from 1 to 4. Clear all the Malfunction with the auto-scan.
But when i went for a test drive nothing happens when i use the cruise control no activation light in the dash.
So i try again. Nohing happens. So i try again coding with the engine running and without Clearing the Malfunction with the auto-scan. Nothing again.
The only thing i did not do is use the Long Coding Helper to activate Bit 5 on Byte 5 ( and Replace 0 with 1 on third digit of Binary ).
I don't know how to access the Long Coding Helper.
I'm using VCDS Release 21.9.0
Thank you for your time guys
I just finish installing my turn signal switch and cruise control on my 2005 Audi A3 S line Sportback 3.2 V6. My turn signal switch is a type 1 Ref. 8P0 953 513 B my previous switch was a type 1 as well, my cars steering wheel control module is a 1K0 953 549 AF which is a Midline variant, I've done the coding. I started with the engine so [01 – Engine] [Login – 11] Enter 11463 to activate cruise control. The engine coding was accepted. Then i coded the Steering Wheel module so [16 – Steering Wheel] [7 - Coding] [00xxx?x] I change the number before the last digit from a 1 to a 4. The Steering Wheel module accepted the coding.
I did all the coding with the ignition on engine not running, I check if the coding on the Steering Wheel module had register it had change from 1 to 4. Clear all the Malfunction with the auto-scan.
But when i went for a test drive nothing happens when i use the cruise control no activation light in the dash.
So i try again. Nohing happens. So i try again coding with the engine running and without Clearing the Malfunction with the auto-scan. Nothing again.
The only thing i did not do is use the Long Coding Helper to activate Bit 5 on Byte 5 ( and Replace 0 with 1 on third digit of Binary ).
I don't know how to access the Long Coding Helper.
I'm using VCDS Release 21.9.0
Thank you for your time guys